Hersteller: Jura | Typ-/Modell: Giga X8c Professional | ca. Baujahr: 2017
Purchased this machine couple weeks ago and it was properly emptied for shipping as described in the manual to avoid freezing.
Had to replace all hoses with proper silicone hoses since someone used vinyl instead and they were all stiff and kinking.
Now the machine is stuck on filling system over and over, can't even access the menu.
The machine is taking water, all water ends in the dump drawer, none goes to the front spouts.
Also noticed that only one pump out of 3 is running (the one close to the ceramic valve)
Little blue 28W steam pump, and the back bottom Sysko pump both are silent.
Any ideas?
Should all pumps prime when the filling cycle is active?
I did try to prefill the other intake circuit that feeds those 2 pumps, no change.
Checked both intake flowmeters, and they look clean without any contact oxidation.
Thanks
Mechanische Kenntnisse vorhanden: JA | Elektrische Kentnisse vorhanden: JA | Messgerät vorhanden: JA
Purchased this machine couple weeks ago and it was properly emptied for shipping as described in the manual to avoid freezing.
Had to replace all hoses with proper silicone hoses since someone used vinyl instead and they were all stiff and kinking.
Now the machine is stuck on filling system over and over, can't even access the menu.
The machine is taking water, all water ends in the dump drawer, none goes to the front spouts.
Also noticed that only one pump out of 3 is running (the one close to the ceramic valve)
Little blue 28W steam pump, and the back bottom Sysko pump both are silent.
Any ideas?
Should all pumps prime when the filling cycle is active?
I did try to prefill the other intake circuit that feeds those 2 pumps, no change.
Checked both intake flowmeters, and they look clean without any contact oxidation.
Thanks
Mechanische Kenntnisse vorhanden: JA | Elektrische Kentnisse vorhanden: JA | Messgerät vorhanden: JA
Dieser Beitrag wurde bereits 2 mal editiert, zuletzt von Lifeisfun ()