Jura Z5 Impressa - short circuit direct when powercord in socket, also with powerswitch off

    • Jura Z5 Impressa - short circuit direct when powercord in socket, also with powerswitch off

      Hersteller: Jura | Typ-/Modell: Z5 Impressa | ca. Baujahr: 2020

      Directly when putting the powercord in the socket it short circuits. Also when i have the powerswitch Off!

      I chamged powerswitch and cord.. it worked an hour.. but now it again short circuits.

      I dont understand anymore where to search?

      I fixxed one leak. The ventil near the brewunit solenoid was leaking..

      Someone who can tell me wat to search for?

      Mechanische Kenntnisse vorhanden: JA | Elektrische Kentnisse vorhanden: NEIN | Messgerät vorhanden: JA

      Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von Amo ()

    • Hello,

      I had yesterday exactly the same problem with a Z9.
      Only 3 parts of the machine can cause the problem
      at the Z5, if it is the FI-switch that "falls".

      One of the two heaters or the electromagnet that
      pushes the drainage-valve has a short-circuit to
      ground. May be even or again caused through
      humidity.

      In my case I had to replace the left heater because
      of a defective heating-coil.

      If the date of build is really 2020, make shure that
      there is no waranty left on the machine.

      BS
      Immer logisch und Schritt für Schritt vorgehen. Blinder Aktionismus kostet Zeit und Geld.
      Küche: Jura GIGA 5 Pianoblack-Chrom Bj: 2012
      Büro: [sJura GIGA X3 ALU Bj: 2014

    • BlackSheep schrieb:

      Hello,

      I had yesterday exactly the same problem with a Z9.
      Only 3 parts of the machine can cause the problem
      at the Z5, if it is the FI-switch that "falls".

      One of the two heaters or the electromagnet that
      pushes the drainage-valve has a short-circuit to
      ground. May be even or again caused through
      humidity.

      In my case I had to replace the left heater because
      of a defective heating-coil.

      If the date of build is really 2020, make shure that
      there is no waranty left on the machine.

      BS
      thanks bs.

      I took of the heaters, didnt see any problems (leaks).. i didnt try the magnet.. thanks!

      Its a z5.. had to be 2010 :) no warranty!
      INFO-VIDEO

    Hilfe zur selbstständigen Reparatur von Kaffeevollautomaten (Jura, Delonghi, Siemens u.v.m.)